Bose FreeSpace DS 100SE Manual

The Bose FreeSpace DS 100SE is a high-performance, weather-resistant loudspeaker designed for commercial and architectural audio applications. It features a 4.5-inch full-range driver, a 1-inch tweeter, and a proprietary Articulated Array® design for wide, even coverage. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Weather-resistant enclosure, Articulated Array® speaker design, integrated mounting bracket, and high-power handling.

Installation

Unpack and inspect contents. Ensure mounting surface is stable and secure.

1. Choose mounting location: Select a secure surface that can support the speaker's weight.
2. Mount bracket: Use provided screws to attach mounting bracket to surface.
3. Attach speaker: Secure speaker to bracket using locking mechanism.
4. Connect wiring: Use spring-loaded terminals for secure connection.
5. Test installation: Ensure speaker is firmly mounted before operation.

WARNING! Speaker is heavy; use proper lifting techniques. Ensure all mounting hardware is secure.

First-Time Setup

Connect to amplifier and configure system settings.

1. Connect to amplifier: Use appropriate gauge speaker wire to connect to amplifier outputs.
2. Set amplifier power: Ensure amplifier output matches speaker power handling capabilities.
3. Configure system: Adjust equalization and volume levels on amplifier or system controller.
4. Test audio: Play audio through system to verify proper operation.

CAUTION! Ensure amplifier is turned off during connection to prevent damage.

Specifications

• Driver Complement: 4.5-inch full-range, 1-inch tweeter.
• Power Handling: 100W continuous, 400W peak.
• Frequency Response: 70Hz - 16kHz (±3dB).
• Sensitivity: 89dB-SPL, 1W at 1m.
• Impedance: 8 ohms.
• Coverage Pattern: 120° H x 120° V.
• Weather Resistance: IP55 rated.
• Dimensions: 8.5" H x 8.5" W x 7.5" D (216mm x 216mm x 191mm).
• Weight: 6.6 lbs (3.0 kg).
• Operating Temperature: -40°C to 70°C (-40°F to 158°F).

Controls and Settings

Speaker operation is controlled through connected amplifier or system controller.

Amplifier Controls: Volume, equalization, input selection, power.

System Controller: Zone selection, source selection, preset configurations.

Speaker Settings: No user-adjustable controls on speaker itself. All adjustments made through connected audio system.

Connecting Devices

Connect to amplifier using appropriate speaker wire.

1. Turn off amplifier before making connections.
2. Strip insulation from wire ends (approximately 3/8 inch).
3. Connect positive (+) wire to red terminal, negative (-) wire to black terminal.
4. Ensure connections are secure and no bare wire is exposed.
5. Route wires safely away from traffic areas and potential damage sources.

Tip: Use weather-resistant wire for outdoor installations.

Operation

Operate through connected audio system.

1. Power on amplifier and audio sources.
2. Select appropriate input source on amplifier or system controller.
3. Adjust volume to desired level.
4. Monitor audio quality and adjust equalization if necessary.
5. For multiple zones, select correct zone on system controller.

WARNING! Do not exceed recommended power levels to prevent speaker damage.

Accessibility Features

This product is designed for commercial installation. Accessibility features are implemented through connected audio system controls and interfaces.

Care & Cleaning

Disconnect from power before cleaning. Use soft, dry cloth only.

CAUTION! Do not use liquids, solvents, or abrasive cleaners. Do not spray directly with water.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits for commercial use. Copyright © Bose Corporation. All rights reserved. For support, visit www.bose.com or contact Bose Professional support.

Troubleshooting

Service: Contact Bose Professional support or authorized service center.

Warranty: Refer to Bose warranty documentation for terms and conditions.